MEP-802A / MEP-803A WiFi  & 2-Wire Remote Start Controller Kit

Description

Remote Start Controller Kit
For use in MEP-802A & MEP-803A Generators
WiFi Remote Control & 2-Wire Start/Stop
Features include:
- Generator Remote Start/Stop via WIFI using a cell phone, laptop, tablet, etc. Anything with WiFi and a browser!
- Direct WiFi communication. No router needed. Works during power failures.
- 300 foot plus WiFi range. Password protected
- Browser display of all engine and generator operating parameters on remote WIFI device. Parameters nearing extremes are highlighted in red text.
--> Ambient Temperature
--> Battery Voltage
--> AC Voltage
--> AC Output Frequency
--> %Load
--> Fuel Level
--> Coolant Temperature
--> Oil Pressure
- Remotely Enable and Disable the Auxiliary Fuel Pump
- Remote control of the Contactor with the Contactor state displayed
- User calibration of all parameters
- Data Logging of all parameters as well as engine hours and Start/Stop count. Min, Average & Max values logged every 10 seconds.
- Two wire remote Start/Stop for use with ATS, Charge Controller or a basic switch
- Transfer between WIFI and Manual control while running
- Automatic Pre-Heat below 40 degrees F
- User programmable durations and delays for all phases of start up and shutdown. Separate settings for WiFi Start/Stop and 2 Wire Start/Stop
--> Pre-Heat duration
-->
Fuel System prime duration
-->
Cranking duration
-->
Warm up
-->
Stop command to contactor open delay
-->
Cool down delay
- Antenna and connector are IP65 rated for water resistance.
- Retains full manual control of the generator thru it's front panel
- Controller is conformally coated to prevent corrosion
- Wire harness utilizes Mil Spec Air Frame wire rated to 300 F
- Includes Controller, wire harness, antenna, drill template, Stainless Steel mounting hardware for installation & manual
- A video all about the Remote Start Kit is available on YouTube.  Search "MEP 802A MEP 803A Remote Start Kit"
- If you'd like a copy of the Installation and Users Manual to read beforehand just send me a message on ebay.
Once built each Controller is tested in a generator simulator and then installed in an MEP-802A, tested and initially calibrated to assure a defect free unit.
Customer support provided to assist with installation.
* Free Shipping.   Returns accepted within 30 days.